Energy
Charging an electric car with solar power: wallbox, surplus and smart home
At midday your own photovoltaic system supplies more power than the house needs. How surplus charging works, why it needs a minimum output and how car, heat pump and water heater share the solar power.

If you have a photovoltaic system on the roof and an electric car in the garage, you want to connect the two: the power from the roof should go into the car and not into the grid for a small payment. This works well when charging station, meter and control system work together.
How does surplus charging work?
An energy meter at the house connection continuously measures whether the house is currently drawing power from the grid or feeding power in. If it is feeding in, that is the surplus. The control system passes this value on to the charging station, and the charging station adjusts its output so that as little as possible still flows into the grid. If a cloud moves in or the oven starts, the charging power drops, and afterwards it rises again.
So you need three things:
- a charging station that can be controlled externally,
- a measurement at the house connection,
- a control system that links the two: the inverter's energy management or the smart home.
Why doesn't the car start charging with just a little sun?
An electric car can't charge as slowly as you like. The lower limit is 6 amps per phase. That means:
- single-phase: around 1.4 kilowatts,
- three-phase: around 4.1 kilowatts.
If the surplus is below that, charging doesn't start or it draws the rest from the grid. Good charging stations therefore switch between single-phase and three-phase charging by themselves. That way charging begins as early as the morning at low power and uses the full system at midday.
Which charging modes make sense?
In practice, three settings are enough:
- Surplus only: The car charges exclusively with power from the roof. Ideal if it is often at home during the day.
- Surplus with minimum charge: Up to a set charge level the car charges straight away, and it gets the rest from the sun. That way there is always enough range.
- Immediate: full power, wherever it comes from. For the day before a long drive.
What matters is that you can change the mode easily: in the app, on the wall panel or with a push button in the garage.
How much range does the surplus give you?
Depending on the car, one kilowatt hour is enough for about five to six kilometres. If the car charges for four hours with three kilowatts of surplus, that is twelve kilowatt hours and therefore around 60 to 70 kilometres. So a sunny half day is already enough for the average commute.
Surplus charging pays off most when the car is at home during the day: when you work from home, at the weekend or as a second car. If you drive off every morning and come home in the evening, you'll mainly charge with sun at the weekend.
Car, heat pump, water heater: who gets the power first?
A house usually has several consumers for the surplus. An energy management system sets the order, for example:
- first the household,
- then the battery storage up to a minimum level,
- then the car,
- then the water heater and heat pump, which produce heat in reserve.
The order can be changed by season. In summer the car gets more, in winter the heat pump. The article Saving energy with a smart home shows what this means in everyday life.
What applies to the installation?
The charging station is connected by a qualified electrician with an installation licence. They check the house connection, register the charging station with the grid operator and fit the protection the standard requires. In apartment buildings, load management is added so that several cars don't overload the connection.
We take care of the part after that: we integrate the charging station, photovoltaics, storage and heat pump into the smart home, set the order with you and show everything in one view.
And the car as storage for the house?
Bidirectional charging, meaning power from the car battery back into the house, is the next step. Today it only works with a few cars and charging stations. If you are planning a charging station now, you should therefore look for good control and an open interface. You need both for surplus charging anyway.
Conclusion
Surplus charging doesn't need exotic technology, but it does need three parts that talk to each other: charging station, measurement and control system. With automatic phase switching and a clear charging mode, you'll drive on power from your own roof for a large part of the year.
More on this: energy management and smart home control.

In person
Philip Fiumi
Managing Director
Questions about Energy?
Write or call. We’ll advise you with no obligation and get back to you within one working day.
More articles
News

Home network wiring: network sockets, switch and Wi-Fi in a single-family home
Good Wi-Fi starts with cables in the wall. How many network sockets a house needs, which cable makes sense, where the central point belongs and what is possible in an existing house without cutting into walls.

Security camera on your house: what is allowed in Switzerland
A camera on your own house doesn't need a permit, but it may film neither the pavement nor the garden next door. The key rules on field of view, warning sign, storage period and sound, plus tips on the technology.

From X10 to Matter: where the smart home comes from
The idea of a house that thinks along is fifty years old. A short history of home automation, from a Scottish plug socket to a common standard.